Fitting guide

This is a general guide. Every car is different, and the airbag is a safety device, so if you're not confident, have a garage or auto electrician fit your wheel. Most fits take 30–60 minutes.

Before you start

  • Park with the wheels pointing straight ahead and take the key out.
  • Disconnect the battery negative terminal and wait at least 10 minutes. This lets the airbag system discharge.
  • Take a photo of every connector before you unplug it.

Removing the old wheel

  1. Release the airbag. Most cars have release clips behind the wheel at 3, 6 and 9 o'clock, reached with a small screwdriver.
  2. Unplug the airbag connectors and place the airbag face up somewhere safe. Never place it face down or near heat.
  3. Unplug the button and paddle connectors.
  4. Undo the centre bolt and mark the wheel's position on the column so the new wheel goes on straight.
  5. Lift the old wheel off the splines.

Fitting the new wheel

  1. Feed the connectors through, line the wheel up with your mark and push it onto the splines.
  2. Tighten the centre bolt to the torque in your car's workshop manual.
  3. Plug in the button, paddle and airbag connectors until they click.
  4. Clip the airbag in place.
  5. Reconnect the battery with nobody sitting in the driver's seat.

After fitting

  • Turn the ignition on and check the airbag warning light goes out after the self-test. If it stays on, stop and get it checked. An airbag fault is an MOT failure.
  • Test every button, the horn and the paddles.
  • Some cars need coding to switch on paddles, heating or buttons. We tell you before you order if yours does.
  • Tell your insurer about the change. A new steering wheel counts as a modification.